WORKSHOP WELL UNDERWAY!
Should be ready to rock Saturday!
Until then, here’s an old VFC I did.
Similar Posts
ANOTHER BOLT READY TO GO HOME (almost).
Got the dirt out, reshimed, greased, couple of new parts and once she’s rewired off she goes.
EPM-1 MAGS
So, I know what you’re going to say. “Mine are fine” Well good for you. I’m telling people that if you use EPM-1 mags you can cause serious damage to…
MAGPUL PDR
Thankfully this will be the last airsoft tech job I’ll ever need to do on a PDR. Fucking terrible. Don’t ask me to do another, I really won’t.
KWALATEE TEK SKILLZ
Because nothing says ‘job well done’ better than a jammed inner barrel, rolled up duck tape holding in a knackered bolt cover & clip, bent springs, splayed lower receiver, broken…
SUCH A LONG WINDED DICKBAG OF A GUN
This is the King Arms FAL. It’s an original version circa 2005, which means it SUCKS to take apart & reassemble. No popping a pin out & getting to the…
I’M CHEATING THE SYSTEM…
I have a gun that I don’t know if I can modify & if I can, I may need parts made. It’s almost last on the list but I need…